Save this article
Use this article for free on your own website
Republish this article for free on your own website or blog. Or search or browse for more articles that your audience will appreciate. Huge choice available. Ideal for finding quality, free content. Read our publishers guide.
How To Remove Old Linoleum
One of the biggest challenges that homeowners face is removing old linoleum. It's a daunting task, but there are tricks you can use to make the job a little easier. The level of difficulty really depends on several underlying factors, like the type of adhesive and the age of the linoleum. If you're putting down a new floor it may be easier just to leave the linoleum intact, especially if it's solidly bound and not cracked or heaving. If it needs to go, you're in for a big job.
One of the biggest challenges that homeowners face is removing old linoleum. It’s a daunting task, but there are tricks you can use to make the job a little easier. The level of difficulty really depends on several underlying factors, like the type of adhesive and the age of the linoleum. If you’re putting down a new floor it may be easier just to leave the linoleum intact, especially if it’s solidly bound and not cracked or heaving. If it needs to go, you’re in for a big job.
In a perfect world, the linoleum and adhesive would lift together. Unfortunately, that’s just not likely. You won’t know what’s in store until you remove the initial layer of linoleum. If the underlying floor is made of concrete it can be relatively easy to remove the old adhesive. Wood floors, however, present a much bigger challenge. Most people use paint scrapers or razor blades to remove the old adhesive. This is fine on concrete, but wood floors require a gentle touch. Old adhesive can hard enough to damage blades and scrapers, so be prepared to stock up.
One piece of advice is not to try and remove everything at once. Many people instead cut the linoleum into strips or sections, and peel that off. You should pull up most of the surface, and likely a good portion of the backing. Doing it this way will make it easier to get at the adhesive underneath as well.
When the top layer is removed and you’re down to bits of adhesive, it’s time to get scraping. There are a few options to clean away the old glue. According to consumer reviews, Krud Kutter and other chemical solvents can make the job easier. If you decide to use any of these products, make sure that you read the instructions carefully. Be sure to wear gloves and a ventilation mask. Work one small area at a time before moving on to the next.
Some home renovators have had success using boiling water to soften the adhesive. Working one section at a time, pour the water directly onto the backing and adhesive. Leave it to soak, and then scrape up the softened debris. Another option is to lay a folded towel over the adhesive, pour the boiling water, let it set and then begin scraping.
Direct heat is a great way to soften old linoleum adhesive. Find an inconspicuous area of flooring, and use a hair dryer and putty knife to scrape away the glue. On hardwood floors, you must push the scraper in the same direction as the natural grain of the wood, or you’ll be left with a damaged floor. Keep a durable pan nearby to hold the scrapings, and be sure that it won’t melt or burn if it comes in contact with the heat source or hot materials.
A heat gun can be a great tool in removing old linoleum adhesive. You’ll need to be careful not to scorch or char the wood. It’s also important to know that this method can cause softened adhesive or mastic to creep into any of the natural crevices and the cracks between floorboards. Work a very small area, with a constantly moving heat source. Scrape as quickly as possible for best results.
It’s virtually impossible to remove every bit of old adhesive from a hardwood floor, and too much scraping can easily damage the wood. Use the above methods to take away as much old adhesive as possible. Then, take a break to consider your next step. Some people choose to lightly sand away any remaining adhesive, while others use mineral spirits and turpentine to scrub it off. However you choose to clean your wood floors, remember this important final step: seal the wood to protect it before you lay any new adhesives or coverings.